Home
08-08-2009
12-08-2009
23-08-2009
29-08-2009

As I testfitted all components in a previous session, I started to make the final install on the styrofoam in the nose witch houses the gel-battery.

To be sure the battery and styrofoam, witch houses it, is not moving I secured it with two dots of construction foam.

Installed the waterbox and strapped it ( standard material )

Installed the fuel tank and strapped it.
{Copyright (C) 2009 Superjet1200.nl All Rights Reserved}
05-09-2009
Superjet 1200 Project

Throttle cable witch is standard superjet needs to have an additional 2cm thread.(M7)
The inner cable from the standard throttle cable is to short to fit the carbs.

So I cut 2cm extra thread and took away 2cm outercable.

Air intake's are PROK filters.
Internal they have a cone for better intake-air flow.
Then the job started to make the final installation on the cooling hoses.
All hoses that I used are original Yamaha rubber hoses,
they don't deform, don't get hard, keep their original shape etc.

I never use plastic, or PVC, for above reasons.
12-09-2009
13-09-2009
Contact